ENGINEERING ENGINEERING 41 belt flange Belt flange Belt flange Belt flange belt can be directly bent and launched. There are the following three types, each with the height and roller diameter determined. If there is a reverse R, you need to be careful. The belts can be bent upward. The following three methods are applicable. The flange height and drive roller diameter are specified for them. Care must be taken when there is reverse R. Spiral and rod bending type 10% Spiral and rod bending type 14% Rod bending type 16% U-shaped rod insertion bending type ■Relation between flange inside height and drive roller diameter 0 10 20 30 40 50 60 70 80 100 200 300 400 500 0 Flange in height [mm] Flange inside height roller diameter [mm] Roller diameter roller diameter and flange height Relation between roller diameter and flange height spiral and rodending type Rodending type Rodending type Rodending type Rodding type Relation between roller diameter and roller width 10 26-type Rod-type Roding type Relation between roller type U-type Roding type
RkJQdWJsaXNoZXIy NDY3NTA=