interviewInterview by job type

Graduated from the Faculty of Science, Quality Assurance Department Y. Joined the company in 2020

In order to deliver products that satisfy our customers, we will use our products.
Conduct strict quality control and auditing.

  • #1-3 years
  • #Technical positions
  • #Graduated from the Faculty of Science
  • #Domestic

Support manufacturing sites to provide high-quality products stably.

We strictly control the quality of conveyor belts and other products manufactured by our company in accordance with the international standards of the Organization for Standardization (ISO). The Quality Assurance Department, which I belong to, begins with obtaining ISO certification, checks whether the operation of the quality control system at each factory meets the standards, and prepares various documents required by customers, including inspection reports.
I am mainly in charge of various measures related to ISO 9001 certification registration and certification. In addition, by operating this quality management system throughout the company, we provide support to manufacturing sites so that we can stably provide products that satisfy our customers.

I want to further improve my knowledge and understanding of standards and acquire the necessary skills.

Even with our strict quality control, it is quite difficult to fully meet your needs. If we are unable to reach the customer's required level, we will thoroughly analyze the cause and work together with the manufacturing site to prepare a report and submit it to the customer. In addition, we always keep in mind that measures to lead to improvements are of paramount importance, such as responding to customer visits directly to the factory and conducting audits to ensure that improvement measures are being implemented on-site.
Since I joined our company, I have been involved in ISO9001, so I have little knowledge and experience, and I am currently working with the support of senior employees. In the future, I would like to further enhance my knowledge and understanding of standards, and to gain experience as an auditor by actively engaging in audits. In the future, I would like to acquire the necessary skills so that I can take the initiative in conducting ISO9001-related registration screening activities.

When I was a student, I thought and attitude I learned through research.
It's useful for my current work.

When I was a student, I majored in control engineering at the Faculty of Engineering, and I don't have a direct relationship with my current work, but I think the logical thinking acquired through research and the attitude of working patiently on things can be used in my current work. Also in my previous job, I belonged to the Quality Assurance Department, and I was mainly in charge of product inspection work, so there are many common parts in terms of handling measuring instruments and troubleshooting, and it is very useful for daily work.

one day scheduleA day schedule

8:45
Start-up, email check

I'll check the work for the day.

9:30
Inspection of incoming products

New products are available in Kansai wire mesh every day. The points to be noted and the content to be measured vary from product to product, and the variety of varieties are varied, so we work with sales to keep an eye on defective products from passing to customers.

11:00
Preparation of documents to be submitted to customers

New products are available in Kansai wire mesh every day. The points to be noted and the content to be measured vary from product to product, and the variety of varieties are varied, so we work with sales to keep an eye on defective products from passing to customers.

12:00
Lunch
12:45
Move to factory and conduct audits

The Quality Assurance Department may visit factories directly to audit whether they comply with the requirements of the quality management system.

17:00
Return to work, check the details of tomorrow's work
17:30
End of work